Zephyr ION Owner's Manual download pdf (Page 8)

8

Getting Started

Prepare the stand and docking bracket

Set up the stand and docking bracket:

Prepare the sled for the camera

• Set up your stand at about chest

height.

• Use one or more sandbags to

stabilize the stand.

• Put the docking bracket on the

stand and tighten the docking

bracket locking knob.

• Push the button at the end of the

aircraft pin and pull the aircraft pin

out of the yoke.

Adjust the monitor position:

• Position the monitor and battery

sliding rods as shown. If required,

you may need to temporarily

remove the locating pin for

the monitor rod to achieve this

extension.

• Add the accessory weights to the

rods as shown. For starters, use

1 middle and 1 starter weight on

each tube.

• Tilt the monitor to about 45 degrees.

Adjust the gimbal position:

• Slide the gimbal close to the top of

the center post, but always leave

enough space between the gimbal

and the stage to accommodate the

docking yoke (about 1in/25mm).

.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Comments to this Manuals

No comments