Zephyr Milano Wall ZMI-M90BG Installation Guide download pdf (Page 11)

1. Measure from range top to hood bottom and mark line A. (26”

minimum from range top) .

2. Plum and mark center line.

3. Mark mounting height line B. (18 5/8” from line A)

4. Mark mounting spread from C/L. (11 1/4”)

5. Fasten (2) M6 x 1-1/2” screws into studs on line B but do not

tighten all the way. Note: Wood blocking may need to be

added behind the drywall if no studs are present. Wall

anchors may also be used but check local codes for

compliance. Failure to use suitable wall anchors and

screws to hold the weight of the hood could result in

personal injury or damage to cooking surface or counter.

6. Remove tape and (2) screws securing electronics mounting

bracket to hood. Reposition electronics mounting bracket as

shown in (FIG. B #3) and secure to motor housing using the (2)

previously removed screws.

7. Remove (2) screws securing electrical junction box to

electronics mounting plate. Remove junction box. (FIG. B # 1)

8. Remove the (1) aluminum mesh ﬁ lter.

9. Hang hood onto the mounting screws and hand tighten each

screw. (FIG. A #1) Secure third M6 x 1-1/2” screw through inside

of hood into wall for extra support. (FIG. A #2)

10. Center and attach duct cover mounting bracket to wall just

below the ceiling or sofﬁ t using (2) M6 x 1” screws.

11. Install electrical and duct work. Seal duct work with aluminum

duct tape. Re-install electrical junction box with cable lock and

install the electrical. (FIG. B #2)

12. Power up hood and check for leaks around duct tape.

13. Place telescopic duct covers onto hood and extend inner (top)

duct cover upwards and secure to duct cover bracket using (2)

M3.5 x 8 screws.

14. Place canopy over hood body and secure it to hood body using

(4) 3/16 x 1/4 screws through ﬁ lter opening.

15. Reinstall aluminum mesh ﬁ lter.

* If using hood in recirculating mode you must secure the air diverter

plate onto wall before installing duct work and duct covers. Turn

to page 10 for more details.

11 1/4”

18 5/8”

Brackets are

pre-installed

26” min

CAUTION: At least two installers are

required due to the weight and size of the

hood.

WARNING: Electrical wiring must be done by a qualified person(s) in

accordance with all applicable codes and standards. This range hood must be

properly grounded. Turn off electrical power at service entrance before wiring.

Installation – Mounting the Hood

Cable Lock

Motor Housing

Cable Lock

A cable locking connector (not supplied) might

be required by local codes. Check with local

requirements and codes, purchase and install

appropriate connector if necessary.

FIG. A

FIG. B

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 41 42

Comments to this Manuals

No comments

Zephyr Milano Wall ZMI-M90BG Installation Guide Page 11

Comments to this Manuals

Related products and manuals for Cooker hoods Zephyr Milano Wall ZMI-M90BG