Zephyr AK7548BS Installation Guide download pdf (Page 20)

www.zephyronline.com

RF REMOTE MAINTENANCE:

Clean the remote control using non abrasive detergents

Follow instructions below for replacing battery.

Using a small ﬂ at head screwdriver, raise the cover of the battery

door (A) in order to access the battery compartment. FIG. 2.

Remove the battery and replace with battery type A23 12V.

Negative end of battery should face the spring inside the remote.

Re-install battery door and recycle old battery.

RF REMOTE FEATURES:

The RF remote control is equipped with a magnet on the back for easy

storage. The remote may be placed on any magnetic surface such as a

refrigerator or the Zephyr remote holder, FIG. 1. The remote holder can

be inserted into a standard electrical outlet for easy storage. Note: The

remote holder does not charge the RF remote.

Maximum remote control communication distance is 15 feet from the hood.

SYNCHRONIZATION: To create a unique link between your hood and remote control please follow these steps:

1. With hood off, press and hold the “lights” button on the hood until the letter “F” shows on the display screen.

2. Press the “lights” button on the remote, the lights on the hood will turn on and synchronization is complete.

RF REMOTE FUNCTIONS:

FIG. 1

FIG. 2

Blower On / Speed Selection

Press to power on blower and cycle through all six blower speeds.

Blower On / Power Off

By pressing , the blowers will power on at the last speed setting. Press

again and the entire hood will power off, including lights.

Delay Off

Lights On / Dim / Off

Switch lights On by pressing once, again to dim and again to switch Off.

Blower On/

Speed Selection

Blower On/

Power Off

5 Min Delay Off

Lights On/Dim/Off

By pressing , the blower and lights will enter Delay Off mode. A dot will

appear in the lower right corner of the hood display indicating the function

is on. The blower will change to speed 1 and shut down after 5 minutes.

FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compli-

ance could void the user’s authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer

or peripheral device. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device

may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause

undesired operation.

THE RF REMOVE CONTROL IS AN OPTIONAL

ACCESSORY NOT INCLUDED WITH THE HOOD AND

MUST BE PURCHASED SEPARATELY

Features & Controls – Optional Remote Control

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 55 56

Comments to this Manuals

No comments

Zephyr AK7548BS Installation Guide Page 20

Comments to this Manuals

Related products and manuals for Cooker hoods Zephyr AK7548BS