Zephyr ADL-M90BSX User Manual download pdf (Page 13)

- 13 -

REMOTE CONTROL

SYNCHRONIZATION:

To synchronize the remote control with the range hood for the first time, proceed as

follows:

1. With the range hood off, press and hold the “Power” and “Delay Off” buttons on theremote for

4 seconds (Fig. 1a) until the “Delay Off” indicator on the hood illuminates (Fig.1b).

2. Press the “Delay Off” button on the hood within 4 seconds to confirm the link (Fig. 2).If

successful, the “Delay Off” indicator will blink 3 times. The range hood is now syncrhonized

with the remote control. If you experience anyproblems, repeat the procedure.

GENERAL INFORMATION:

- Remove any protective film from the remote surface prior to using it.

- The remote control has a range of approximately 10-15 feet.

- The remote control is equipped with a magnetic base and may be attached to ferrous

surface for easy storage.

- The remote top is made of a plastic material and is prone to scratches.

Use care when handling and cleaning the remote; we suggest using a microfiber cloth to

clean it.

- The remote control will enter a sleep mode after 20 seconds of inactivity to conserve

battery life. Press any button for one second to wake the remote.

BATTERY REPLACEMENT:

The batteries will last approximately 8 months, depending on usage.

1. Remove rubber cover from bottom (Fig.3).

2.Using an object such as a screwdriver or pen, gently place it in the center opening in

the bottom of the remote and push inwards to dislodge the top touch panel from the

remote body. (Fig. 4)

3. Press on the metal spring located in the battery tray to dislodge battery. Replace both

batteries with type 3V CR2450 (Fig.5). Re-assemble by following instructions in reverse.

3 54

FCC Caution: To assure continued compliance, any changes or modifi cations not expressly approved

by the party responsible for compliance could void the user’s authority to operate this equipment.

(Example - use only shielded interface cables when connecting to computer or peripheral device. This

device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1)

This device may not cause harmful interference, and (2) This device must accept any interference

received, including interference that may cause undesired operation.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

No comments

Zephyr ADL-M90BSX User Manual Page 13