Zephyr ZMD-M90AS Installation Guide download pdf (Page 13)

Installation – Mounting the Hood

7. Remove tape securing electronics mounting bracket to hood. (FIG. F, #1) Position electronics mounting bracket

as show in (FIG. F, #2) and secure to hood body using (3) M4 x 8 truss head sheet metal screws.

8. Lift hood body and align the (4) pre-installed mounting screws on top of blower housing (FIG. A, #5 on Page 9) with

the (4) key holes on the bottom of the support frame. (FIG. H) Slide hood towards the narrow end of key holes to lock

in place. Hand tighten each of the (4) screws to secure hood to bottom of support frame. Install (1) M4 x 12mm safety

screw into bottom support frame to further secure the hood. (FIG. H, #1)

9. Install electrical and duct work. Seal duct work with aluminum duct tape.

10. Power up hood, verify all functions and check for leaks around duct tape.

FIG. F

ELECTRONICS

MOUNTING

BRACKET

FIG. H

CAUTION: At least two installers are

required due to the weight and size of the

hood.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

No comments

Zephyr ZMD-M90AS Installation Guide Page 13