Zephyr ZGE-E36AS User Manual download pdf (Page 17)

Decorative Mesh Filter Clean Reminder (metal mesh filter)

Whether your hood is installed as an exhaust or purifying unit, a decorative mesh filter is fitted by the factory. This

mesh filter is intended to filter out residue from cooking. It need not be replaced on a regular basis but is required to

be kept clean. After every 30 hours of use the Filter Clean Reminder function in the microprocessor will automati-

cally remind you by a flashing when the mesh filter needs to be cleaned. The filter can be cleaned by hand

with non-abrasive soap or in a dishwasher. A heavily soiled filter should also be soaked in grease cutting

detergent prior to cleaning.

Decorative Mesh Filter Clean Indicator

When flashes on display, the mesh filter installed is

required to be cleaned. This will occur after every 30

hours of use.

Re-setting Function

Reset the filter clean reminder timer when filter is cleaned

and re-installed. With hood off, press and hold for

approximately 5 seconds until on display disappears

. . The filter clean reminder function is now reset

and a new 30 hours elapse cycle is initiated.

Clean Filters

display < F > flashes

hold 5 sec. display from < F > to < >

To Reset

Charcoal Filter Replace Reminder (charcoal filter, if installed)

When your hood is installed as a recirculating unit it must be fitted with a charcoal filter to purify exhaust and fumes

from cooking and then recirculate the air within the home. This charcoal filter must be replaced after every 120 hours

of use. The charcoal filter should never be cleaned or placed in a dish washer.

The charcoal filter replace reminder function in the microprocessor needs to be switched on. When switched on, the

microprocessor will elapse and count usage time. When charcoal filter replacement is needed a flashing will

appear on the display.

Setting the Charcoal Filter Replace Reminder

With hood off, hold for approximately 5 seconds.

The display will change from (exhaust mode) to

(recirculating mode). This indicates that the elapse

timer function is switched on and charcoal filter is being

used.

Charcoal Filter Replace Indicator

When the display starts flashing, the charcoal filter

needs to be replaced. Purchase replacement charcoal

filters from Zephyr.

Re-setting Function

After charcoal filter is replaced, with hood off, press and

hold for apprimately 5 seconds until on the

display disappears . The filter change reminder is

now re-set and a new 120 hour elapse cycle is initiated.

hold 5 sec. display from < - > to < C >

Set Mode

display < C > flashes

Change FIlter

hold 5 sec. display from < C > to < >

To Reset

Features & Controls – Filter Clean and Replace Reminder

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 48 49

Comments to this Manuals

No comments

Zephyr ZGE-E36AS User Manual Page 17

Comments to this Manuals

Related products and manuals for Cooker hoods Zephyr ZGE-E36AS