Zephyr Milano Wall ZMI-M90BG Installation Guide download pdf (Page 15)

SURFACE MAINTENANCE:

Clean the hood surface periodically with hot soapy water and clean cotton cloth. Do not use corrosive or

abrasive detergent, or steel wool/scouring pads which will scratch and damage surface.

For heavier soil use liquid degreaser.

After cleaning it is recommended that you use non-abrasive stainless steel polish/cleaners, to polish and

buff out the stainless luster and grain. Always scrub lightly, with clean cotton cloth, and with the grain.

Do not use any product containing chlorine bleach. Do not use “orange” cleaners.

Aluminum Mesh Filters

The aluminum mesh ﬁ lters installed by the factory are intended to ﬁ lter out residue and grease from

cooking. They need not be replaced on a regular basis but are required to be kept clean.

After 30 hours of use the words “clean mesh ﬁ lter” will illuminate on the control screen indicating time to

clean the aluminum mesh ﬁ lters. Refer to instructions on page 12 on how to reset the indicator. Filters

may need to be cleaned more depending on cooking habits.

Remove and clean by hand or in dishwasher on low heat. Spray degreasing detergent and leave to soak if

heavily soiled.

Dry ﬁ lters and re-install before using hood.

Removing Aluminum Mesh Filters

1. Push in on spring loaded handle

2. Pull down on ﬁ lter hande to remove ﬁ lter

Should ﬁ lters wear out due to age and prolonged use,

replace with following part number:

Hood Model: Part No. Qty to Order

ZMI-M90BS/BG 50200044 1

Maintenance – Hood and Filter Cleaning

1 2 ... 10 11 12 13 14 15 16 17 18 19

No comments

Zephyr Milano Wall ZMI-M90BG Installation Guide Page 15